Low Resistance Measurement Bridge

At this level it is important to use test equipment that will minimize errors introduced by the test lead resistance and or contact resistance between the probe and the material being tested.

Low resistance measurement bridge.

Below figure shows the schematic diagram of kelvin double bridge. The kelvin double bridge incorporates the idea of a second set of ratio arms hence the name double bridge has come and the use of four terminal resistors for low resistance arms. For measurement we make the ratio p q equal to p q and hence a balanced wheatstone bridge is formed leading to null deflection in the galvanometer. Wheatstone bridge use for measuring the resistance from a few ohms to several kilo ohms.

Wheatstone bridge along with operational amplifier is used to measure the physical parameters like temperature strain light etc. The second set of ratio arms p and q is used to connect the galvanometer to a point d at the appropriate potential between points m and n to eliminate the effect of connecting lead of resistance r between the known resistance r and the standard. The limitations of the kelvin bridge are requires manual balancing. Its additional complexity over the basic wheatstone design is necessary for avoiding errors otherwise incurred by stray resistances along the current path between the low resistance standard and the resistance being measured.

We can also measure the quantities capacitance inductance and impedance using the variations on the wheatstone bridge. The kelvin bridge is a variation of the wheatstone bridge which enables low resistances to be measured. R is the unknown low resistance and s is a standard resistance. The wheatstone bridge is used for measuring the very low resistance values precisely.

A low resistance measurement is typically a measurement below 1 000 ohm. A kelvin double bridge is a variant of the wheatstone bridge used for measuring very low resistances. The measurement range would typically be 1mω to 1kω with the smallest resolution of 1µω. The wheatstone bridge was originally developed by charles wheatstone to measure unknown resistance values and as a means of calibrating measuring instruments voltmeters ammeters etc by the use of a long resistive slide wire.

This is the reason because of which the wheatstone bridge is modified and the kelvin bridge obtains. But error occurs in the result when it is used for measuring the low resistance. The kelvin bridge is suitable for measuring the low resistance.